Comment on Calibration test prints all look the same
Danno@lemmy.world 11 months agoThe filament’s a week out of the vacuum sealed bag - other than running it through the dryer to be safe, how can I tell it needs to be dried?
Will run through the guide, thanks.
Erikjuh@kbin.social 11 months ago
Wet filament can give popping sounds while extruding, and indirectly cause stringing because of the moisture evaporating in the extruder. This causes filament to ooze out because of the high pressure. But since its a week old it's most likely fine.
rikudou@lemmings.world 10 months ago
Not necessarily, I’ve got a wet filament a few times from a freshly opened box.
rambos@lemm.ee 11 months ago
You are right, but sometimes you get vacuumed wet filament