Erikjuh

@Erikjuh@kbin.social

• ⁨Comment⁩ on ⁨Calibration test prints all look the same⁩ ⁨⁨1⁩ ⁨year⁩ ago⁩:

  Wet filament can give popping sounds while extruding, and indirectly cause stringing because of the moisture evaporating in the extruder. This causes filament to ooze out because of the high pressure. But since its a week old it's most likely fine.

• ⁨Comment⁩ on ⁨Calibration test prints all look the same⁩ ⁨⁨1⁩ ⁨year⁩ ago⁩:

  Step 1: make sure you have dry filament.
  Step 2: follow this guide: https://ellis3dp.com/Print-Tuning-Guide/

  8 mm retraction sounds like waaaay too much, a direct drive printer should print fine with under 1 mm retraction.

• ⁨Comment⁩ on ⁨Prusa MK4 or Bambu labs p1s⁩ ⁨⁨1⁩ ⁨year⁩ ago⁩:

  I was in the same position, doubting between a mk4 and a p1s. Decided to build a Voron instead, no regrets.