Comment

Comment on Possible over extrusion, any advice appreciated!

When you say pressure of the z-axis, do you know what they meant exactly? Not sure it could be temp as it’s the same, however I did change the part cooling fan in case that was faulty and the material wasn’t cooling fast enough

source

Sort:hotnew top

monotremata@kbin.social ⁨1⁩ ⁨year⁩ ago
Could still be temperature if the thermistors on e printers read differently--that is, the same setting doesn't necessarily work out to the same physical temperature on two printers, even if they're the same model, because the thermistors vary. My suspicion would be that you're printing a little hot, and the filament is contracting after it's extruded. On the first few layers it can't shrink much because of all the material in the middle, but on the vase mode layers there's nothing preventing it.

source
- Prismo@lemmy.world ⁨1⁩ ⁨year⁩ ago
  So a combination of three changes finally got me back the correct result.
  
  Changed the nozzle for a brand new one, that helped a lot but still had a fee issues.
  
  Remeasured my extrusion amount and recalibrated the e-steps, they had gone quite a way out.
  
  Reduced the temp by 10°C apart from the first layer.
  
  Thanks for your help!
  
  source