The one thing I didn’t like about klipper firmware on my CR-10 was the default filament runout setup. One of my first big prints (with expensive ApolloX filament) ran out. The default klipper setup waits something like an hour, with the hot end still hot, then completely shuts down.

So my home position was lost, and with a partial part on the plate, there was no way of re-homing, so it was a wasted part.

Make sure your filament runout timeout is set to 24 hours (and I think I might have made the temp lower so it didn’t burn?)

I like klipper on mine, too. I do wish the default mesh would be loaded at startup, but it doesn’t load any mesh. Which doesn’t really matter, I guess. I have four build plates, three different styles, so I’m running bed levelling pretty much every print anyways.