Comment on Did Bambu Lab change something on the A1 recently?
akilou@sh.itjust.works 1 week agoYour first theory was mine as well. Although the power strip doesn’t specify what the threshold is; I can set it to low/med/high. It’s set to low.
For your second idea, I’ll test it, but I believe it stays on indefinitely, not just for a few minutes after boot up
Bronzie@sh.itjust.works 1 week ago
Unless the meassurement in your strip is wrong, I’d guess like you two that something in the FW makes it draw slightly more at idle.
An easy way to test this is to revert to an older FW. Can be done easily in Handy.
If that fixes it, you know it’s the printer. If not, then it’s probably the sensor in your strip.
Good luck!