No visible hole in the model. Maybe there’s something funky going on with the model
Comment on PrusaSlicer putting overhangs in mid-air
LastYearsPumpkin@feddit.ch 1 year ago
Is there a hole in that nub? It looks like it’s trying to do the walls around the hole in the nub.
MrQuallzin@lemmy.world 1 year ago
IMALlama@lemmy.world 1 year ago
This is the answer with anything based on slic3r in my experience.
Is this your model @op? If yes, you can add two rectangles to either side of the hole that are 0.25mm or so in height to serve as a built in bridge and trick the slicer.
MrQuallzin@lemmy.world 1 year ago
Not my model (Added source to my post). That was a good idea, though. What I ended up doing (and can’t believe I didn’t think of it sooner. Been a long day…) is adding a 0.2mm disk right at the problem height and it’s looking good!
IMALlama@lemmy.world 1 year ago
I got the idea while building my Voron - the designers bake a lot of tricks like this into their files. I’ve adopted a lot of them to improve printability and am happy to share the knowledge!