Comment on Any ideas why the top roof warped like it did?
floquant@lemmy.dbzer0.com 1 month ago
Excessive cooling maybe? Or the support gap is too tall?
Edit: might also be nozzle temp too low
Comment on Any ideas why the top roof warped like it did?
floquant@lemmy.dbzer0.com 1 month ago
Excessive cooling maybe? Or the support gap is too tall?
Edit: might also be nozzle temp too low
mortalic@lemmy.world 1 month ago
I took the default prusa slicer snug setting. Though I will check tomorrow to see what else might be set. I remember when reading up on organic supports that there were some suggested changes to support settings. Maybe I changed something… I don’t think so though.