Comment on (UPDATE: a different issue??) What are these burn marks on my failed 3D print?
myplacedk@lemmy.world 1 month ago
but it does not explain the weird burn mark of my initial failed print.
I guessing that when it was falling over, part it got taller. (Think of a 199 cm tall cabinet in a 200 cm room. It can’t fall over, it will hit the ceiling.)
As it got taller, the nozzle could dig in.
As the nozzle got embedded in the plastic, the heat would melt some plastic, and the dirt would stock to the warm molten sticky platic.
Ohh, that makes sense. I think that’s probably it. Next time, I will scale down my prints as to not reach the height limit.
But I am still running into the issue where filament isn’t correctly adhering to the build surface!