Comment on How to properly get rid of holes between perimeters?

• MrTolkinghoen@lemmy.zip ⁨1⁩ ⁨month⁩ ago

  Calibration of a printer is very much a cumulitive thing. Looking at your print I think your PA is off, but I would guess that it’s a combination of multiple settings. When calibrating a filament, I usually do a sweep of calibrations, and then sometimes even come back to past steps to rerun since the values can impact eachother.

  I.e. I typically do in this order per brand of filament type. Always starting with the closest preset I can find. Usually the generic version if there isn’t the brands of exact filament as a preset in orca.

  Temperatue

  Max volumetric speed

  Pressure advance

  Flow

  Retraction

  Sometimes back to PA because flow can impact PA

  VFA/input shaping (optional)

  And then toss a tolerance calibration at it at the end, but I don’t typically do this per filament, just do it per printer unless you’re about to print some super tolerance intolerant parts

  source