Comment on What's causing this?
thisbenzingring@lemmy.today 2 months ago
it’s not being adhesive, trying a 5+ degrees might help. try setting drawing the outside parameters first.
Comment on What's causing this?
thisbenzingring@lemmy.today 2 months ago
it’s not being adhesive, trying a 5+ degrees might help. try setting drawing the outside parameters first.
stoicmaverick@lemmy.world 2 months ago
It’s both first layers and higher. No pattern I can find. Bed adhesion is definitely fine, I haven’t had a single lifted corner since I started using the SuperTac plate.
thisbenzingring@lemmy.today 2 months ago
the pattern is pretty wonky, your slicer isn’t doing you any favors. try a different top and bottom pattern if the other suggestions don’t do anything