Comment on Belt Holster for USB Power Supply
Trilogy3452@lemmy.world 3 weeks ago
What material did you print it with?
PETG, because it’ll likely get some direct sunlight. I would have used ABS but my venting window is snowed in.
Just keep in mind PETG isn’t strictly UV resistant. A later reprint with ASA would be better.
Do people paint ocer it to make it UV resistant?
I was thinking of softening but that’s a good point. Ill probably do it in ABS if it fails in PETG.
ABS is even less UV resistant. 😅
nik282000@lemmy.ca 3 weeks ago
PETG, because it’ll likely get some direct sunlight. I would have used ABS but my venting window is snowed in.
Natanox@discuss.tchncs.de 3 weeks ago
Just keep in mind PETG isn’t strictly UV resistant. A later reprint with ASA would be better.
Trilogy3452@lemmy.world 3 weeks ago
Do people paint ocer it to make it UV resistant?
nik282000@lemmy.ca 3 weeks ago
I was thinking of softening but that’s a good point. Ill probably do it in ABS if it fails in PETG.
Natanox@discuss.tchncs.de 3 weeks ago
ABS is even less UV resistant. 😅