Comment on Finally finished my first RC car
UserNotFound@lemmy.world 9 months agoI see, thanks for explain.
Driveline is no need to lubricate, because it’s belt drive system. Parts fit well, bearings, belts etc (although, that depends on how well calibrated is your printer). I think that system is strong enough. I built it with brushless motor and it’s wild.
Only challenging parts were ball joints. I had problems to fit them in place, but I found a way.
Asstronaut@lemmy.world 9 months ago
Awesome thanks for the info! Which filaments did you use?
UserNotFound@lemmy.world 9 months ago
PLA Prusament Lipstick Red (body) Polyterra Charcoal Black (chassis) Polyterra Fossil grey (inside) Filament PM(Czech brand) graphite black (seats) Filament PM white Filament PM Pearl Red (cage)
ASA Prusament Lipstick Red (for few parts)
MrAnderson@feddit.nl 8 months ago
I wasn’t expecting plain PLA! Are there any issues with warping due to heat from the motor?
UserNotFound@lemmy.world 8 months ago
It’s recommended to use PC or ASA for motor parts. I used ASA