With the super tack cool plate Bambu recommends removing the print while warm. Don’t wait for the bed and part to cool. And DON’T wipe with IPA. Soap and water only when needed.

I bought one when they were on sale just before Christmas. It’s not a plate I intend to use a lot. Any part that has a good flat base isn’t meant to be printed on the super tack plate. Only those designs sketchy bed adhesion at best and can’t be printed with supports.

I did use it to print a storage sheath for a fillet knife I have. I was very impressed that I was able to print a rectangular hollow tube with 2mm wide base and 165mm tall vertically with no supports or brim. It was a fine test of my skills as a designer, printer calibration, and the super tack.