Comment

Comment on What does the bed mesh in Fluidd show? My prints are good, nothing to complain about, but I see the bed mesh doesn't look so good.

AverageGoob@lemmy.world ⁨1⁩ ⁨week⁩ ago

What I have used as a rule of thumb is to keep the difference below .2, .6 is a huge difference in my mind and is making your printer work much harder to compensate for the large difference.

source

Sort:hotnew top

fufu@feddit.org ⁨1⁩ ⁨week⁩ ago
Klipper with proper mesh and a reliable Probe on a fixed bed can handle 1mm range without any issues at all.

source
- nieceandtows@programming.dev ⁨1⁩ ⁨week⁩ ago
  how would I do that?
  
  source
  - fufu@feddit.org ⁨1⁩ ⁨week⁩ ago
    either have something like KAMP handle your meshing adaptively before every print (takes more time every print, will work even with different bed);
    
    or by having a fixed bed without any adjustable screws/etc., creating a proper bed_mesh (eg bicubic with an amount of probe_count on the higher side) and loading it in your print_start before every print. (will always work aslong as the bed/setup stays the same. Gotta remesh when you change beds)
    
    source