Comment on How do I improve the overhangs on my Artillery Genius?
marcos@lemmy.world 3 days ago
Temperature, speed, flow rate, cooling.
In other words, close to anything. Follow a calibration guide. Also keep in mind that some filaments just don’t make good overhangs.
FuglyDuck@lemmy.world 3 days ago
Very few printers are going to be able to do 90 degree overhangs even close to nicely. Bridging? Sure. With significant overhangs, it’s always going to wiggle a bit until you get some more layers.
If OP weren’t using this to get as close as possible, I’d say the answer was organic supports coming in from the bed.