Comment on Fuck. My. Life. đ
Mr_Mofu@lemmy.blahaj.zone â¨4⊠â¨days⊠ago
3 Thoughts as I had simular Issues!
Is the Bed Leveling correct? A Loose Print Head can give false results, big issue I had once with my P1S.
Try Changing the width and Hight of the First Layer to smaller Values, no clue Why, but it Fixed this kinda issue before for me!
In Software, Is the Model Properly put on the Ground and not floating? Happened to me before, since Supports where turned off I didnât notice it
FuglyDuck@lemmy.world â¨4⊠â¨days⊠ago
reducing the width of the first layer seems counter intuitive to me. usually adhession is improved by using widths wider than the nozzle since the plastic has to get smooshiefied into the surface. I donât know thereâs much difference on the first layer 125%-200% of the nozzle width, but I find going over definitely helps. (I use 150% for stronger parts in general.)
or at least thatâs been my experience. nozzle height/z offset would be the first thing for me to check, but PLA shouldnât be warping that bad, IMO, so there might be some thermal issues as well.