Comment

Comment on Is this nozzle too low or bed temperature issue?

I usually have to run mine between 62-65, kinda depends how cold my house is but that’s the same bed I have on my sovols, also get a playing card and make sure you can barely feel the nozzle on the surface of the card. That’s how I do mine

source

Sort:hotnew top

nieceandtows@programming.dev ⁨1⁩ ⁨week⁩ ago
The default glass bed works perfectly at 60. I’m wondering if there’s a temperature difference between the glass plate below and the pei plate above.

source
- CmdrShepard49@sh.itjust.works ⁨1⁩ ⁨week⁩ ago
  To test this you could heat the bed up for 10 or 15 minutes before starting the print so that the new PEI sheet gets saturated with heat. I don’t think this is your issue though as you can print PLA without a heated bed at all.
  
  source
- Jaeger86@lemmy.world ⁨1⁩ ⁨week⁩ ago
  Honestly it looks like the nozzle could be too hot cause I don’t see any consisten lines
  
  source
jokeyrhyme@lemmy.ml ⁨1⁩ ⁨week⁩ ago
slightly off topic:

do you have the bed start at e.g. 60 for the first layer and then 65 for subsequent layers?

does raising the temperature mid print like this help with warping or something?

source
- Jaeger86@lemmy.world ⁨1⁩ ⁨week⁩ ago
  I start at 62, at lower I would experience warping and bad bed adhesion
  
  source