Comment on Got my first printer, what else do I need? Any tips on setup?
neidu3@sh.itjust.works 1 month ago
An STL file describes an object/shape. This needs to be translated into actual print instructions such as move to X/Y position, squirt plastic, move again, etc. This is what a slicer does: It “translates” from a shape to actual print instructions. I’m not sure, but I’ve always assumed that it’s called slicing because it takes the 3D object and creates many vertical slices with print instructions.
I don’t know about your printer specifically, but I guess it takes Gcode (which is what you get as output from a slicer) like most other printers? I suggest you grab PrusaSlicer as it’s very flexible and supports a lot of different printer defaults. Load your STL in there, slice it, transfer the result to your printer, and you should in theory be good to go.
Tip: Start with something small.
clay_pidgin@sh.itjust.works 1 month ago
I appreciate the help! Starting small, aye.
I’ve not seen the steps between STL and plastic model before so that’s where I will be learning. I’m excited!
runner_g@piefed.blahaj.zone 1 month ago
start out with a calibration print such as a benchy or XYZ cube using the default settings. if it looks wrong, Google the “symptoms” and go from there. modern printers take less fiddling than printers from 10 years ago so hopefully you won’t need to do much.
clay_pidgin@sh.itjust.works 1 month ago
That’s what I’m hoping! I’ve got two friends that have printers and I’ll get more tips from them.
runner_g@piefed.blahaj.zone 1 month ago
nice!
neidu3@sh.itjust.works 1 month ago
The only step you’re missing is basically what I described above. I recommend grabbing PrusaSlicer, load your STL, and play around with it, as it shows after slicing the various print instructions it comes up with. For starting out, the defaults should work fine.
clay_pidgin@sh.itjust.works 1 month ago
Will do, thank you very much!