Comment on Dialing in Settings
SpikesOtherDog@ani.social 1 week ago
Looking almost functional!
Curling up is a heat issue combined with the change in extrusion and flaky first layer. Glass bed is set to 50, but I prefer it at 60-65 if I recall.
Still seem to have some issues with my feed motor clicking while feeding. I should probably calibrate my steps before I go too much further.
SaveTheTuaHawk@lemmy.ca 1 week ago
Been years since I’ve seen people use glass beds. Better off with a PEI plate. PLA should not pull off the bed.
hereiamagain@sh.itjust.works 15 hours ago
I just changed from glass to PEI, night and day difference
SpikesOtherDog@ani.social 1 week ago
My esteps were way off, by about 20%. Also, I was having clogging issues due to my tube not seating properly and causing clogs. I’m impressed that it printed at all.
After addressing the basic issues, I no longer saw any warping.
Also, I’m totally down for a magnetic PEI bed.