Comment on My linocut block printing experiment with PLA
daannii@lemmy.world 4 days agoI think it could definitely be used for designs that don’t require perfect printing. So something like fabric block printing or making printed wrapping paper or something like that.
I’m going to try petg too and I’ll report back if it makes a difference. Since petg is slightly more flexible I think that means it might have a slightly softer shore value. But I’m not sure if it “rebounds” much.
I primarily carve gray linoleum mounted to masonite.
The lenoleum has like a coarse burlap layer on the backside. I can’t recall where I bought it but I bought it in bulk so I have a lot. Maybe Blick.
Then I had a buddy with a table saw cut me up a bunch of masonite rectangles. And I glue the lenoleum to it.
Anyway.
What I was getting at is that the lino is hard but it still has a little flexibility before I mount it. And a matte surface.
I think that very subtle flexibility helps a lot with getting a good print. So maybe finding a 3d printable plastic with those same properties is key. Even the difference between pla and petg could be enough.
I have also carved rubber sheets. These are significantly easier to carve but I find that details get lost when making the prints because it squishes too much.
I also don’t think the ink lays on it as evenly. But that could just still be the squish issue. But those prints never look as good as the lino.
Oh and as for the TPU.
So I used 95a, which I believe is the hardest common one out there.
I looked up Bambu guides on printing it. You can’t print it with a 0.2 nozzle on the printer I have (A1).
So far I’ve noticed since I am using a 0.4 nozzle, there are always areas on the 3d prints where filament is missing.
Like on the cat nose. And multiple areas on the molotov plates. It’s where walls meet the horizontal layers. Sometimes it makes tiny gaps.
Too small to be much of a problem for normal printing uses. But for block printing, it is a problem.
Possible solutions would be finding a material that could fill these holes. But I can’t think of any that would get into such small holes.
Or try printing with 0.2 nozzle. Which I will be trying.
But can’t do that with the TPU.
Anyway. That’s my assessment and plans.