In what way did they fail?
Comment on best print farm 3d-printer for PETG?
dorkage@lemmy.ca 4 weeks agoI had a K1 Max I got directly from Creality in October.
It would print ASA okay, but PETG and PLA failed like 75% of the time.
Switched to a Sovol SV08 with a cartographer and I can’t remember having a failed print since. I print almost exclusively in PETG now.
akincisor@sh.itjust.works 4 weeks ago
dorkage@lemmy.ca 4 weeks ago
Terrible bed adhesive. Cleaned the bed multiple times. Tried with and without glue sticks. It had over 2mm of deviation.
Prints would always warp on the right side where the aux fan was blowing on them.
akincisor@sh.itjust.works 4 weeks ago
I guess I’m lucky… My bed has <0.6mm deviation. I’ve had it for a couple of months printing almost every day and my biggest issue is an occasional layer shift.
EmilieEvans@lemmy.ml 4 weeks ago
dorkage@lemmy.ca 4 weeks ago
I flashed to mainline shortly after getting it. I didn’t have any issues with stock firmware, only swapped because if the cartographer.
If you don’t mind minor amounts of tinkering to get it good, it’s been great since switching to the Cartographer.