Comment on Is a Voron 3D printer worth it??
wjrii@lemmy.world 1 day agoI know the beds are worse, apparently almost all of them. Sovol chose to change the Voron reference design to be cheaper and it’s just not held down right, so they exhibit beating degrees of “taco” a way inconsistency that the diagram accentuates visually. Mine has a corner that seems to be about 0.4mm too high, and the rest is a bit wavy to lesser amounts. This is the main reason I set it to redo its z offsets before every print.
The Sovol doesn’t use standard extrusion profiles so it’s less moddable, it’s hot end is not completely standard, and it uses injection molded parts in places the Voron uses 3d printed parts (that last may be be an advantage, lol). The Sovol also doesn’t run a completely clean version of Klipper. I think it’s set in a way to make it work a little better with their cheaper BOM.
It’s big and fast and Voron-like, but it’s just not a hand crafted super printer like a Voron can be.
froh42@lemmy.world 18 hours ago
Look on github for Rappetor’s SV08 mainline repository. You’ll need a new mmc or sd card (both are ok) and a “five bucks” STLink programmer, but then it is quite easy to put mainline klipper on your sv08.
That’s the prerequisite for using a probe. like a btt eddy on a SV08, for example.
wjrii@lemmy.world 17 hours ago
Thanks! I am going to keep those all in my back pocket for when the honeymoon of not having a $99 “box o’ parts” Voxelab wears off, though I feel a little guilty for never installing that BLTouch clone now.
I haven’t printed much with the Sovol yet. So far, the main things I’m running into are bed adhesion (the old standby of a washable glue stick is helping), and I’ve had a couple of vertically oriented parts get knocked off the bed, and slowing down quite a bit helped.