Comment on Pressure advance with BTT SmartFilamentSensor v2
Rolive@discuss.tchncs.de 19 hours agoActually this isn’t exactly my setup. I forgot the pin number and copied the example piece instead.
Comment on Pressure advance with BTT SmartFilamentSensor v2
Rolive@discuss.tchncs.de 19 hours agoActually this isn’t exactly my setup. I forgot the pin number and copied the example piece instead.
ExcessShiv@lemmy.dbzer0.com 19 hours ago
Ah OK makes more sense then.
As for detection length, default is 7mm for encoder-type sensing according to klipper documentation. So 10mm is far from excessive and you should be able to bump it even more just to check.
Is your extruder direct drive or bowden?
Rolive@discuss.tchncs.de 16 hours ago
I have a direct drive. Indeed I want the runout length as short as is reasonable.
ExcessShiv@lemmy.dbzer0.com 16 hours ago
What did you set your event and pause delays to?
Rolive@discuss.tchncs.de 10 hours ago
Ah, I see the problem. I messed up the calculation, instead of .072 PA I used 0.72. The part that got printed looked quite bad as well so that explains a lot. I’ve entered more normal values and now it looks much better.
Thanks anyway!