even better, add [screws_tilt_adjust] to take advantage of the crtouch and a little fancy computer math to make leveling super easy.
https://www.klipper3d.org/Manual_Level.html
ender beds use M4 screws
Comment on Got klipper up and running on the new Ender-3 V3 se
im_mr_clean@lemmy.world 9 months ago
To your printer.cfg I’d add:
[exclude_object]
Allows you to cancel individual items. If you have multiple items printing and one fails in one way or another you can cancel just that object and continue the rest of the print. Literally the only thing is add the bracketed thing to the cfg and it’ll add a icon next to the pause button that gives you the options.
I’ve also found that one of the bed screw leveling options is very helpful for getting the bed close enough for the bltouch to really be dialed in. I use
[bed_screws] Screw1: 32.5, 202.5 Screw2: 32.5, 32.5 Screw3: 202.5, 32.5 Screw4: 202.5, 202.5
Then in the console run: bed_screws_adjust
Just moves the nozzle to each of the four corners right above the leveling knobs. Makes it pretty simple. I will add that the coordinates I use are fore a ender3pro but should be the same ish for you. But don’t quote me on that.
hibbfd@kbin.social 9 months ago
0xd34d@sh.itjust.works 9 months ago
I’m going to look into adding this in, thanks for the tip!
0xd34d@sh.itjust.works 9 months ago
So I add that as an include from another config. It’s saved me from a few complete failures 😁. For this I was trying to keep it as a basic config for others to use as a good base and I would like to submit a PR, eventually, to include it in klipper’s example configs.