Thanks for the advice I will give it a shot.
Comment on zits and bubbles on large layers
ExcessShiv@lemmy.dbzer0.com 5 days ago
I’ve had this happen if there a bit too much squish on the first layer. The level may look good and work for parts with smaller areas, but it compounds for large bottom areas and caused similar effects for me. Increasing distance to bed by 0.01-0.02mm or so fixed it for me.
PriorityMotif@lemmy.world 5 days ago
roofuskit@lemmy.world 5 days ago
Exactly this, the first layer is smooshing and tearing up and that is being carried through the subsequent layers.
Since the bottom is so thin there’s no infill layers to reset the density to normal. If there was infill it would build over that damage and then lay fresh new layers on top effectively hiding it unless you’re looking at the bottom.
I would also check your hotend, while cold, to make sure it’s not loose. It can cause similar issues by dragging the nozzle.