Comment on cannot get an even first layer with a voron trident
Where could that twist be?
My guess would be from one side of the x-axis to the other, because then on one side the nozzle to probe offset would be less in Z then on the other. But it could also be anywhere else. Can you check if your frame is square?
I am constantly manually tweaking Z offset at the start of prints so here’s hoping the heatsoak solves that.
Nilz@sopuli.xyz 1 day ago
My guess would be from one side of the x-axis to the other, because then on one side the nozzle to probe offset would be less in Z then on the other. But it could also be anywhere else. Can you check if your frame is square?
muusemuuse@lemm.ee 1 day ago
I am constantly manually tweaking Z offset at the start of prints so here’s hoping the heatsoak solves that.