Comment on CNC design with ballscrews.
dual_sport_dork@lemmy.world 1 day ago
A CNC for what, milling? If so, I agree with the others here. Using belts to drive a milling machine is likely to result in too much backlash to be viable. The entire point of ballscrews is that they’re (reasonably) proof against backlash, even moreso than regular lead screws. We can get away with it on our printers because in normal operation the print head and nozzle are never supposed to touch anything so it doesn’t matter. For milling, backlash in your movement system will cause your tool to kick itself off of the workpiece when its edges touch it (i.e. hundreds/thousands of times per minute) which will make it chatter, result in lousy finishes and accuracy on your parts at best, and most likely wind up with you breaking a lot of bits.
Maybe you could get away with it if all you’re doing it routering wood, or something. The moment metal enters the equation, forget it.
The key to milling is rigidity, rigidity, rigidity. If you are having chatter problems, accuracy problems, tool breakage problems, basically any kind of problem, nine times out of ten you’ll wind up tracing it back to backlash and/or your machine or clamping arrangement not being rigid enough in some capacity.
Rolive@discuss.tchncs.de 1 day ago
It is meant mostly for milling circuit boards and laser engraving. I believe belts are good enough for that since the bit load is so tiny here.
Later though I want to upgrade to ballscrews and will have to redesign the current machine.
ahmedezat_katteb@lemmy.world 11 hours ago
For PCB isolation milling the thing that usually bites first isn’t X/Y stiffness, it’s Z. Copper clad is never perfectly flat and rarely clamped dead level, and with a V-bit a few hundredths of a mm of height error changes the trace width a lot. Whatever drive you pick, plan for probing (a clip on the bit, the copper as the contact) and a height map / auto-leveling step in your sender; Candle and bCNC both do it. That will matter more for your results than belts vs. screws.
On single vs. dual Y screws: if you go dual later, drive both screws from one motor with a closed belt loop rather than two motors. That keeps them in sync mechanically and avoids the racking/binding problem mentioned above. For a small PCB/laser machine though, one screw under a moving bed is simpler and plenty rigid.
dual_sport_dork@lemmy.world 1 day ago
If that’s all you’re doing you can probably get away with belts. The laser engraving, for sure. Most of the commercial diode laser options are already belt driven.