Ambitious early project.

Hehe yeah, I would have gone with something else as my first project had it not been for the fact that I want these planters soon. I had hoped to get the printer earlier, but after asking for advice on my printer purchase here end of last year, I got a compelling advice to at least wait for first reviews before deciding, and by that time Prusa had a backlog on orders.

I’d probably go with petg.

Due it to being outdoors?

There are plenty of good tutorials / suggestions for general water tightness with regards to slicer settings. Water tight joints will be tricky. Consider sanding and then torching them. I’ve had good results with clearcoat spray after sanding pla. May work with petg too.

Nice, will check that out in more details! Are clearcoats typically non-toxic? Torching the joints sounds like a good idea - what would you typically use for that, a standard crème brûlée burner? I plan on making smaller prototypes to test out any concepts out before making a huge one.

Curious why you didn’t go with xl for this? Cost?

Cost is one major reason, the Core One was at the top-end of my budget, but it is not the only one. The Core One otherwise fit my requirements very well, and the XL would also not be able to print this in one go. This is by far the largest pieces I have planned on printing, and all the other prints on my “todo”-list will fit in it just fine. I wanted one with an enclosure, and I didn’t like the look of the XL with an enclosure, as it will be quite visible where it will be placed, and I’m the kind of person who would care. And I also believe the footprint of the XL is larger? In that case, I am not so sure if it would even fit on the designated space for it.