Comment on PLA in screw hole preventing me from unscrewing the hotend (SV06)

papalonian@lemmy.world ⁨1⁩ ⁨month⁩ ago

• Interstellar_1@lemmy.blahaj.zone ⁨1⁩ ⁨month⁩ ago

  Thanks, I was just worried that it could damage the hotend.

  source

  • BakedCatboy@lemmy.ml ⁨1⁩ ⁨month⁩ ago

    As long as your thermistor or heater block doesn’t fall out you should be fine. But if you want to be safe, just set it to 200 and then turn it off before you unscrew it so that it won’t thermal runaway if it comes apart while working on it.

    source

    • Interstellar_1@lemmy.blahaj.zone ⁨1⁩ ⁨month⁩ ago

      Thanks very much.

      source