Comment on Is this happens becuase of levelling issue?
neclimdul@lemmy.world 4 weeks agoI immediately noticed the floating extrusion. but when you said this i realized they where right next to each other. if thats a bad sensor the manual leveling might work but i wonder if theres something(probably a bit of filament waste) under the sheet causing it to ripple or the build plate isnt very flat.
a high spot during probing could cause havoc on the interpolation and i could see it causing something like this. manual leveling would kinda help that but that spot would still be a disaster.
DeadDigger@lemmy.zip 4 weeks ago
Yeah it’s a weird thing that I would assume cones from bad slicing, a bad bed or bad mesh leveling. But this can have different reasons too
Helkriz@lemmy.world 1 week ago
Sorry I had an emergency and was away. My bed level wasnt good I think. I did some leveling and all again now the prints are fine. Yet still minor (negligible) issues with the print. My nozzle may be not that good now. Its old. But since the prints are fine now so Im using It.
DeadDigger@lemmy.zip 1 week ago
Yeah not a problem. If I don’t get an answer than I just assume it’s solved
Helkriz@lemmy.world 4 days ago
Thanks for the support. My bad to respond late. Thanks.