Pretty bad underextrusion. Is the filament drive slipping?
Comment on Is this just crappy Filament
Feeee23@lemmy.world 5 weeks agoI’ve tried multiple temp towers but they all failed because of the underextrution. So I tried benchys with with 190 and 220°C and have seen little difference. Then I just stuck to 200°C for no other reasons then I’ve used it before
LadyMeow@lemmy.blahaj.zone 5 weeks ago
thisbenzingring@lemmy.sdf.org 5 weeks ago
if it only happens with that filament, its probably just that.
you could try some of the drying methods but that doesn’t look good at all
if you’re sure the filament is good then you want to look at the print settings and physical tensions on the belts and gears. maybe you need to look at the spot where your printer is located. can it add any wobble? one trick in the prusa community is putting your printer on a heavy flat yard paver stone and a thin foam under the paver