I did say it was a lazy design choice. And change gears a mostly made as solid gears. You very seldom see spoke designs. It has to do with casting/machine time costs. So, solid gears are what I think about with change gears. The gears are still cheap to print and they only took a good afternoon to print all 4 gears and the job is done. And the post is about the weird crappy finish I got with GeeeTech PETG. And the simple nozzle swap solving the problem. And at this point, I just want to burn up this spool to just get rid of it. I won’t buy this brand again.

Turned out the real design sticker was that I needed a 16mm keyed center hole to fit the banjo shafts. And while 16mm hole just barely fits on a mod 1 20T gear, the 4mm key needed does not. I ended up modeling the 20T and 80T gears as one piece and the single 20T gear needed to be designed with a solid 30mm round attached to it to have some place for the drive key to go.

The upside to doing it how I did things meant that yesterday I used those 3D printed gears as made to do the lathe job I needed to do, burnishing a section of shaft in my lathe. Sometimes you just gotta go for it and hope it works out. I might even reprint them with a better PETG brand like DeepLee or better yet, MatterHackers and make them with 4 or 5 perimeters and 6 top and bottom layers with 80% gyroid infill. I have both on hand. For the few times I might need a .0025" per rev feed, they might well last for years. If I find a #2 and #6 pair of used gear cutters for cheap, I might buy them and machine a set from steel. But even decent gear cutters are stupid expensive. And if I don’t have a customer to bill the expense out to, it’s probably not worth thinking about.