Comment on Neptune 4 Yea/Nea?
rambos@lemm.ee 1 year agoIts not bad to take apart rods and bearings, clean and relube, but its usually enough to just drop tiny amount of oil on rods and just move your axis back and forth. I do it once a month
Comment on Neptune 4 Yea/Nea?
rambos@lemm.ee 1 year agoIts not bad to take apart rods and bearings, clean and relube, but its usually enough to just drop tiny amount of oil on rods and just move your axis back and forth. I do it once a month
kek_w_lol@lemmy.one 1 year ago
Technically, you’re supposed to pack bearings with grease before installation (put grease inside bearing, plug opposite end with thumb and shove steel rod into the open side), but cheap printer manufacturers rarely do it, so that would be the first thing to do after you get the sv06. After that, your lunrication method is sufficient. But it is still better to repack bearings after a while and clean the rods.