Comment

This is going to sound stupid, but don’t forget to activate bed levelling after performing the leveling measurements. Maybe this is a stupid idea but I put M29 L1 and M29 A at the start of my gcode to load the ubl slot 1 mesh and activate it. Before getting ubl I used M420 S.

I spent way too much time frustrated by bad prints before I learned that leveling wasn’t active.

source

Sort:hotnew top

fubbernuckin@lemmy.world ⁨1⁩ ⁨month⁩ ago
I figured there might be something like this that i hadn’t seen. I’ll look into it tomorrow, i get the feeling this would cause the inconsistency.

source
- moody@lemmings.world ⁨1⁩ ⁨month⁩ ago
  Not sure how it works with your printer, but with mine on Klipper, after bed leveling I have to save and restart the firmware, and then I have to go back and select the profile that I just saved, otherwise it doesn’t use it.
  
  source
  - mvirts@lemmy.world ⁨1⁩ ⁨month⁩ ago
    That ain’t right 😹
    
    Maybe try contacting klipper people github.com/Klipper3d/klipper/blob/…/Contact.md
    
    Or file an issue if you think it’s a bug.
    
    source