TheSun
@TheSun@slrpnk.net
- Comment on Ifixit gives fairphone 5 a 10/10 on repairability and maintanence 11 months ago:
Seems like an honest recommendation to me. You fit the apple use case pretty well, so if it works for you, great. I’d argue a stock pixel using stock android would be comparable in terms of not needing to mess with stuff since its a very curated experience, since google then controls the hardware and software, like apple.
The trade off is you’re giving google (or apple) 100% access and control to everything you do on your phone.
With a fairphone or any other android with (e, grapheneOS, calyxOS, lineage, etc) you WILL need to change some settings, maybe play around with it a bit to get it working how you want, but you are the one in control. Its really not that difficult to develop the small amount of technological knowledge needed given the amount of help available online and I’d say its a necessary life skill these days just like learning to use a computer became a necessary life skill.
- Comment on Merging two objects (I'm a beginner) 11 months ago:
Prusaslicer has some pretty good stl manipulation tools built-in these days. You can merge, split, add common shapes, subtract shapes, etc.
From the outside looking in, it seems like you should be able to do everything you want right in the slicer.
I’ve found this to be preferable for working with existing stl’s (not as useful for editing) if you dont have the actual step files or 3mf files available.
- Comment on Fusion 360 increasing annual price by $190 USD 11 months ago:
Ya TheDuckPrince clearly didnt look very hard for competitors, onshape is great.
- Comment on 3d modeling for printing 11 months ago:
Ya I don’t doubt people have troubles with it since you need winetricks and such. Hopefully they see that github page eventually and get it working.
- Comment on 3d modeling for printing 11 months ago:
Fusion360 can run on linux using WINE, HERE is a GitHub repo showing how to set it up.
Or the web version works on linux too ofc
- Comment on [HELP] PrusaSlicer & Klipper (mainsail) ERROR: Move exceeds max extrusion | SV06 1 year ago:
Thanks for the suggestion. Just tested by adding G92 E0 right after the PRINT_START and PURGE_LINE macros and it still has the same error at the same spot; right as it goes around the circle part of the elbow on the second layer.
- Comment on [HELP] PrusaSlicer & Klipper (mainsail) ERROR: Move exceeds max extrusion | SV06 1 year ago:
I’m not really looking to change slicers at this point. I’ve used Cura in the past and have landed on PrusaSlicer for a variety of reasons and would like to get it working properly again ideally.
- Comment on [HELP] PrusaSlicer & Klipper (mainsail) ERROR: Move exceeds max extrusion | SV06 1 year ago:
sure thing, here is the start of it.
- Submitted 1 year ago to 3dprinting@lemmy.world | 13 comments
- Comment on Klipperized my Sv06 - 10/10 do recommend 1 year ago:
You may have already done this since you mentioned input shaping but said you only changed print speed… dont forget to crank up the acceleration values too (you can find your max good quality when doing input shaping tuning)
- Comment on Klipperized my Sv06 - 10/10 do recommend 1 year ago:
If you use prusa/superslicer I could share my profile tomorrow when I get back home. Started out with the ellis klipper superslicer one and then ported it over to pruasa and have been making a few tweaks here and there.
- Comment on Wall Hitch Mount for Bike Storage 1 year ago:
Nice! Looks like it could double as a maintenance stand too