buzzalejo

@buzzalejo@lemmy.world

• ⁨Comment⁩ on ⁨3D Printing Bed Levelling (Traming) - Simple Concept⁩ ⁨⁨1⁩ ⁨week⁩ ago⁩:

  Thanks for this guide

• ⁨Comment⁩ on ⁨3D Printing Bed Levelling (Traming) - Simple Concept⁩ ⁨⁨1⁩ ⁨week⁩ ago⁩:

  I totally agree everyone should take the time to do things manually. Mesh UI is just for fine tuning from my point of view

• ⁨Comment⁩ on ⁨3D Printing Bed Levelling (Traming) - Simple Concept⁩ ⁨⁨1⁩ ⁨week⁩ ago⁩:

  Hi,

  Thank you for sharing your techniques and thoughts.

  I have two printers.

  • Ender 3 V2 neo (without klipper, default software)
  • Elegoo Neptune 4 Plus (with klipper)

  I found on my Neptune 4 Plus that it had alot of distortions, maybe of how big the print bed surface areas is.

  When doing the levelling, the printer saves the levelling points as a mesh which I can view via the fluid UI where I can see all calibration and control.

  The mesh gives you a good illustration where the distortions are before refining it. That’s how I determine where to place spacers.

  Ill do another auto leveling to see how it improved the distortions. When the mesh shows to a close level, then I refine it in the fluid UI.

• 3D Printing Bed Levelling (Traming) - Simple Conceptlemmy.world ↗
  Submitted ⁨⁨1⁩ ⁨week⁩ ago⁩ to ⁨3dprinting@lemmy.world⁩ | ⁨11⁩ ⁨comments⁩
• ⁨Comment⁩ on ⁨4.2.7 Firmware Installation - Ender 3 V2 Neo⁩ ⁨⁨1⁩ ⁨week⁩ ago⁩:

  My pleasure

• 4.2.7 Firmware Installation - Ender 3 V2 Neo
  Submitted ⁨⁨1⁩ ⁨week⁩ ago⁩ to ⁨3dprinting@lemmy.world⁩ | ⁨2⁩ ⁨comments⁩