ShortCircuit908
@ShortCircuit908@lemmy.blahaj.zone
This is a remote user, information on this page may be incomplete. View at Source ↗
- Comment on Help with Bambu AMS (retraction) 2 weeks ago:
A good idea, I’ll try to rig up some magnetic tube holders to keep it aligned
- Comment on Help with Bambu AMS (retraction) 2 weeks ago:
That’s actually how I had it set up to start, zip-tied under a wire shelf. That configuration takes up a lot more room and leaves very little for filament storage, so that’ll be my last resort if I can’t figure out any other way
- Comment on Help with Bambu AMS (retraction) 2 weeks ago:
No dice. Slot 4 fails most frequently but all slots are affected one time or another
- Comment on Help with Bambu AMS (retraction) 2 weeks ago:
That’s a good idea, I’ll try that
- Submitted 2 weeks ago to 3dprinting@lemmy.world | 8 comments
- Comment on Is this just crappy Filament 3 months ago:
❤️🥒🍭$7**** eeee rrhrhhr nhor/rreirnovnnrr/::: spoiler spoiler nnnrrrrrnhrgnhrnn::: spoiler spoiler
spoiler
no´r* * *
::: :::
n::: spoiler spoiler/nntooononoow~~(ノಠ益ಠ)ノttsg~n:::s~stn´* 1.
1.