skotimusj
@skotimusj@lemmy.world
- Comment on Question about printing times 6 months ago:
As you said. I tried this and it fixed everything. Thank you
- Comment on Question about printing times 6 months ago:
They are flat
- Comment on Question about printing times 6 months ago:
Thanks. Will try this.
- Comment on Question about printing times 6 months ago:
When I switch to 0.2mm the time goes to 83 hours, so I assume there is still some error. What slicer do you use?
- Comment on Question about printing times 6 months ago:
Here is what I remember.
Creality ender 5 s1 Creality slicer High detail profile (Infill % 15, speed 100, nozzle temp 205, bed temp 60, z axis 0.1) PLA These were the default with no changes.
I am not sure what other parameters can be changed.
I will post a screenshot tonight. I did notice that 99% of the time is on the outer wall, this is where I noticed the pauses when I simulate the print.
- Comment on Question about printing times 6 months ago:
Layer height is 0.1mm. it’s odd, because it happens on specific curved areas. There are no pauses on other areas that were recently printed.
- Submitted 6 months ago to 3dprinting@lemmy.world | 19 comments
- Comment on Anybody have favorite Master System games? 7 months ago:
Shinobi and choplifter were my favorites.