Mehthewhatever

@Mehthewhatever@lemmy.world

• ⁨Comment⁩ on ⁨Why does my printer suck so much?⁩ ⁨⁨8⁩ ⁨months⁩ ago⁩:

  I’m not sure about the S1, but I have the ender 3, and had issues with the first layer when I first got it as well! However, I eventually installed jyers firmware and a touch probe on it, and since then, my prints have been flawless ever since, and I haven’t manually leveled my bed in years! I basically used the jyers firmware and touch probe to build a 100 point mesh of my print bed, and then included g code before each print to do a 3 point tilt check to align this mesh to the bed, which basically realigns the virtual mesh to the bed even if it might have shifted! And since it’s only 3 points, it’s super fast and can be ran while the nozzle is heating up before every print!