Dave811

@Dave811@lemmy.today

• ⁨Comment⁩ on ⁨Replacing Cloudflare Tunnels with Tailscale?⁩ ⁨⁨11⁩ ⁨months⁩ ago⁩:

  To be clear I ran that on my reverse proxy server. In the tailscail dashboard you also need to enable the subnet

• ⁨Comment⁩ on ⁨Replacing Cloudflare Tunnels with Tailscale?⁩ ⁨⁨11⁩ ⁨months⁩ ago⁩:

  I didn’t try that, I use the static local ipv4 address of my network. Like http(s)://192.168.1.3:443

• ⁨Comment⁩ on ⁨Replacing Cloudflare Tunnels with Tailscale?⁩ ⁨⁨11⁩ ⁨months⁩ ago⁩:

  So my post was the one to get rid of the cloudflare tunnel.

  Basically I set up a tailscail docker on my home server and connected it with a one time key from tailscale. There I exposed my local network. (Perhaps secure that only to your homeserver IP)

  Then I set up a Debian Server which hosts a lot of other stuff. But there I also installed tailscail and connected it to my account.

  After this the most important part! I wasted hours to find this line of code sudo tailscale up --accept-routes With that you allow the external server to accept routes. Otherwise you can’t redirect to your homeserver

  The next step I took was to install nginx and setup a reverse proxy to my traefik docker on my home network

  Here I routed the domain with every subdomain (*.your.domain) to my homeserver.

  My homeserver took care of the https certificate so my nginx server only redirects traefik from port 80.

  I can share my configs later but I have a little problem with large nextcloud uploads. And I don’t have the previously working nginx config anymore… So I need to dig a bit further again.

  Ask me questions, but I can only answer them in about 7h Hope my late night writing makes sense.

• ⁨Comment⁩ on ⁨Looking for an alternative to cloudflare tunnel⁩ ⁨⁨1⁩ ⁨year⁩ ago⁩:

  So here is the setup for truecharts with traefik and the things needed for proper truecharts setup: truecharts.org/manual/SCALE/…/getting-started

  Do you also use cloudflare tunnel?

• ⁨Comment⁩ on ⁨Looking for an alternative to cloudflare tunnel⁩ ⁨⁨1⁩ ⁨year⁩ ago⁩:

  So I use traefik on my truenas server from the truecharts catalogue. If you need help there I can send you the corresponding links from the truecharts website later, I am not at the computer right now.

• ⁨Comment⁩ on ⁨Looking for an alternative to cloudflare tunnel⁩ ⁨⁨1⁩ ⁨year⁩ ago⁩:

  The problem is with nextcloud on my end. Some files just can’t get synced and bigger files won’t even go through. Perhaps something is misconfigured, but I think I red something, that cloudflare tunnels only support x gb of traffic at once.

• ⁨Comment⁩ on ⁨Looking for an alternative to cloudflare tunnel⁩ ⁨⁨1⁩ ⁨year⁩ ago⁩:

  That’s a good point. But that’s also the point where my tinkering won’t help me… Do you have a writeup or a yt video where nginx points to the wireguard VPN? Another question. If I set up the wireguard tunnel, how can I just route the traffic from traefik?

• Looking for an alternative to cloudflare tunnel
  Submitted ⁨⁨1⁩ ⁨year⁩ ago⁩ to ⁨selfhosted@lemmy.world⁩ | ⁨27⁩ ⁨comments⁩