thebirdwashere
@thebirdwashere@lemm.ee
(formerly grumpycatmakepics, wholetdadogeout on reddit)
- Comment on Monkey business 4 weeks ago:
What the fuck did I just read? If it wasn’t for the dolphin part this would be acceptable
- Comment on Calibration test prints all look the same 1 year ago:
yea, not sure if it was clogged or what, but filament seemed to string from the side of the nozzle, almost like there was a tiny pinhole or something. I also ended up replacing the connector that goes between the hotend and the Bowden tube and also removed a small section of the tube that was in the hot end. Haven’t had issues since (I think we tried tuning it the best we could, and the nozzle was just the final step that got rid of the stringing fully)
- Comment on Calibration test prints all look the same 1 year ago:
I also found that changing the nozzle on my Neptune 2 pretty much solved my stringing issue, although since this printer is only probably a month old that shouldn’t be an issue yet, so just throwing it out there. Although there are a lot of variables that affect it too, it probably took me several months off and on to tune my printer (on klipper firmware) with help.