benzmacx16v

@benzmacx16v@discuss.tchncs.de

• ⁨Comment⁩ on ⁨Help figuring what the two non SAS ports are⁩ ⁨⁨4⁩ ⁨months⁩ ago⁩:

  That is not a plane if you look close. That is thieving. The board layout had no copper there, but this can make the plating process more difficult to get consistent across the board. Usually this is added by the fab house to help them manufacture the board.

• ⁨Comment⁩ on ⁨Housing for resistor?⁩ ⁨⁨1⁩ ⁨year⁩ ago⁩:

  You can get panel mount resistors. They are usually rated at way higher wattage though.

  I would probably just heat shrink the resistor. Your harness should be reasonably secure anyway.

  I would question why you need a 2.2ohm 1/2w resistor in a harness in the first place though.