Trainguy

@Trainguy@lemmy.world

• ⁨Comment⁩ on ⁨My GenX gamer ass whenever someone brings up boomers.⁩ ⁨⁨8⁩ ⁨months⁩ ago⁩:

  I tend to think left 4 dead’s Boomer zombie.

  Slightly unrelated but when people say Zoomer, I often think about the hover bike from the first Jak and Daxter. XD

• ⁨Comment⁩ on ⁨Unable to print TPU 93A⁩ ⁨⁨1⁩ ⁨year⁩ ago⁩:

  These are very edge-case, and I only mention it because you had a lot of helpful details that eliminated stuff, but could the gap between the extruder drive and the hotend opening be too far apart? I’ve had a problem kind of similar where it would jam up the filament there. Otherwise, the other outlandish thing I could think of is maybe the inside of the hotend is pitted and damaged, but that is not as likely.

  I hope this helps at all, or maybe gives you some kind of idea. Good luck!