KremlinJanitor
@KremlinJanitor@lemmy.world
- Comment on [Troubleshooting] It's the clog guy again - temp readings are bad! 6 months ago:
This is really a head scratcher. I’m no Klipper expert when it comes to really tinkering with the printer.cfg, however if I was in your situation the next place I would go with troubleshooting would be on the firmware side of things. Klipper already makes regular backups of your important configs so maybe try making a copy of them and do a clean install of Klipper with a default printer.cfg for your printer and see if that helps narrow down the issue some more. Saves you having to spend money on hardware if you don’t end up actually needing it.
- Comment on Shit posting but 3d this time 7 months ago:
I’d say a Neo based on how the fan shroud looks
- Comment on Need help with Creality Sprite Pro 1 year ago:
So i think the gears might have been jammed something? Now the motor is turning perfectly fine in the correct plug. Must have just shipped that way from the factory i suppose. Thanks so much for the help!
- Comment on Need help with Creality Sprite Pro 1 year ago:
Ok so i swapped the extruder connection to the Z stepper one and it did spin! So the motor’s not bad or the connection. Swapped it back to the extruder socket and nothing. So maybe its something in the Klipper config for the extruder?
- Comment on Need help with Creality Sprite Pro 1 year ago:
Did do that yes. Double checked my config against another Ender printer with the same 4.2.7 board as mine and with the same hot end before starting my calibration.
- Comment on Need help with Creality Sprite Pro 1 year ago:
I run Klipper firmware on this printer not stock Marlin. I usually print PLA at 210 so the temperature cut off wasn’t the problem. I fully heated the nozzle before trying to extrude filament.
- Submitted 1 year ago to 3dprinting@lemmy.world | 9 comments