lapis

@lapis@lemmy.blahaj.zone

• ⁨Comment⁩ on ⁨Rant: Cura did the one thing a slicer shouldn't do⁩ ⁨⁨9⁩ ⁨months⁩ ago⁩:

  Big recommend to just jump straight to OrcaSlicer. It has Bambu Studio’s much-improved-over-PrusaSlicer UI but with features ported in from PrusaSlicer and SuperSlicer and compatibility with non-Bambu printers.

• ⁨Comment⁩ on ⁨Sharp corner algorithm⁩ ⁨⁨10⁩ ⁨months⁩ ago⁩:

  This is definitely not true of OrcaSlicer, at least not anymore. I’m running an 0.6mm nozzle and 120% layer width at 0.2mm layer height results in 0.72mm line width, not 0.24mm.

• ⁨Comment⁩ on ⁨Which slicer do you use⁩ ⁨⁨11⁩ ⁨months⁩ ago⁩:

  Another Orca user here. Started off with PrusaSlicer and switched over at a friend’s recommendation, and honestly am so glad I did (it has a much nicer UI and some really neat features ported over from SuperSlicer).

• ⁨Comment⁩ on ⁨Flexi Christmas Tree ornament (oc)⁩ ⁨⁨11⁩ ⁨months⁩ ago⁩:

  These look great! Can we get a link to the design, please?

• ⁨Comment⁩ on ⁨Voronoi Pumpkin⁩ ⁨⁨1⁩ ⁨year⁩ ago⁩:

  Thanks, and good luck! In Orca, I set it to all walls fuzzy, 0.5mm between points, and 0.2mm depth, and I like the results.

• ⁨Comment⁩ on ⁨Voronoi Pumpkin⁩ ⁨⁨1⁩ ⁨year⁩ ago⁩:

  Thanks for showing us this! I printed one with “fuzzy skin” and it is so cool (unfortunately doesn’t show up well in photos though).

• ⁨Comment⁩ on ⁨Any experience with Sovol SV07?⁩ ⁨⁨1⁩ ⁨year⁩ ago⁩:

  SV06 Plus, SV07, and SV07 Plus all use the same nozzles. However, I think standard volcano nozzles would also work – I just haven’t bothered to try since I bought a five-pack of the proprietary nozzles off AliExpress and they work perfectly fine.

• ⁨Comment⁩ on ⁨Gyroid infil appreciation post⁩ ⁨⁨1⁩ ⁨year⁩ ago⁩:

  I just wish it didn’t take so much longer to print than adaptive cubic at the same infill percent.