🤔 It's fiiiiine...

Comments

• neidu3@sh.itjust.works ⁨2⁩ ⁨months⁩ ago

  I happened to be watching the print camera when a nut suddenly dropped onto the print sheet. Luckily it’s just a short test print, so it gets to complete the current job.

  If I’m not mistaken, it’s one of the nuts holding the XY rail in place. Time to do some tightening I guess.

  source
• anguo@piefed.ca ⁨2⁩ ⁨months⁩ ago

  Are those scratches on the bed? My skin is crawling.

  source

  • neidu3@sh.itjust.works ⁨2⁩ ⁨months⁩ ago

    Some PETG residue after scraping off a notoriously resistant brim a while back. It doesn’t affect the print, but it’s fugly enough that I rarely use that side of the sheet.

    source