Submitted 1 month ago by coke38@lemmy.world to askelectronics@discuss.tchncs.de
Hello everyone, I bought a bottle dynamo for my bicycle with a rear and front light. Though I have one little tweak that I would like to add and that’s a way to keep it light up for about 1 minute (at least 30 sec) without pedaling. I thought of putting a capacitor in the circuit to store some energy but I would like what do you all think of it ?
Thank you for your time and have a nice day you all !
I’ve actually done that with a simple single diode rectifier and a supercap with zener voltage limitation:
If your supercap has a too low series resistance for the LED to light immediately you need an additional resistor in series with it. It is simple and small enough to directly fit inside the original lamp casing and has been working without a problem for over 3 years.
What I wanted to do was something like thatIMG_20240925_092655
Though you seem to have a better knowledge and better circuit. I bought 2 super cap 5.5v so I wanted to put them in series (though get half the capacitance). Your approach seems to be better and I may take it. Though mine should be working ? Keep in mind that I’m a nooby in electronics and I keep learning from the internet so not the best to have solid base…
Does your solution works with 5.5V, the 6V dynamo does not blow it ?
Thank you for your answer I really like it.
Your solution may very well also work, good thinking. A few things to consider though:
Cort@lemmy.world 1 month ago
I could be wrong, but wouldn’t the capacitor keep it from turning on until charged?
coke38@lemmy.world 1 month ago
Yes but it should not be like 30 seconde long I think, so it should be OK for a bicycle :)
embed_me@programming.dev 1 month ago
It should be possible to wire it so that when the battery is on, the light turns on instantly while also charging the capacitor