I replaced my fridge ice maker a few years ago because part of the circuitry burned out. The replacement has also now burned out (though not nearly as badly). For reference, the burned part is supposed to hold onto the end of a copper peg that leads to the heating element (which melts the ice slightly so it can be popped out of the mold).
It seems silly to spend $60 on a new one when it’s just $0.05 worth of copper that needs replacing. Is there a safe way to fix this? Unfortunately, I can’t just solder the connection because it is enclosed when assembled. For reference, those tabs aren’t just fouled, they are burned completely through. My first thought is to pull out the whole trace, solder on new tabs (not sure where I’d get the material), and put the trace back in.
How_do_I_computah@lemmy.world 1 day ago
I really wouldn’t do this. This connector burning up is a symptom not a cause. There’s something in the control circuit not working correctly or your heating element is failing.
I would gladly pay $60 to know my ice maker isn’t going to burn my house down.
evasive_chimpanzee@lemmy.world 1 day ago
It’s electromechanical, so essentially everything is just controlled by the timer rotating and making contact with different circuits. The only control in there is a bimetallic strip that tells the timer that it’s cold enough to rotate.
The heating element itself isnt burnt out or anything like that. Since the connection to the heating element is a round peg, and it’s being gripped by this connector that just sits tangent to the diameter of the peg, there are only 2 small spots that actually make the electrical connection. I’m assuming the tension on the tabs was bad, so the connection was patchy leading to arcing that burned it out.
BarbecueCowboy@lemmy.dbzer0.com 1 day ago
Above could be right though. If you can find a fridge ice maker that has lasted more than a few years without needing repairs, we all need to know. The failure here may be the ‘safety’ feature and continuous functionality may have been an at best minor concern.
I’m always wary of working on heating elements, don’t over engineer it if you try to fix it and it could just be arcing like you suspect… but just remember that the wear/increased resistance on other items leading to that burned out contact may have contributed to that specific piece failing and you maybe should be thankful that it failed.
How_do_I_computah@lemmy.world 1 day ago
What is the resistance of your heating element and what is it supposed to be? If it is lower than it’s supposed to be that can cause it to draw more current than that connection is rated for.