Comment on Creality K1 Max Curves Surface Issue
FuglyDuck@lemmy.world 2 months agoto clarify, other parts that aren’t related to the model, do they print fine? or is it just these pairs of models?
it could be the mesh you’re dealing with is corrupted.
xzot746@sh.itjust.works 2 months ago
Good point, I have mainly been printing these items for the hydroponic tower. I do have other versions that I can check. I think after this set prints I will add some basic shapes in different orientations to see if there is issues still.
That being said I did print some other items that were stacked and each one is much thinner but there are no artifacts on the outer walls.
Image
Krackalot@discuss.tchncs.de 2 months ago
Could try rotating the model 90°. If the issues remain in the same location, you’ll know it’s a printer issue, maybe due to the size of the radius.
xzot746@sh.itjust.works 2 months ago
So I sliced and printed a different model, and then rotated 1 by 180°, it is somewhat weird as the lowest part on the right model seems ok but as the wall built up on the inside it was getting the artifacts. The model on the left was getting the artifacts on the outer piece but not the inner.
Image
In rotating the models after, the artifacts are on the opposite side.
Image
I noticed it was starting at the seam, I have the scarf joint on contour, and noticed that “scarf around entire wall” was checked so trying reprinting to see if that is the issue.
Image
xzot746@sh.itjust.works 2 months ago
Well that was the problem, thanks for everyone’s input.
Image
Image