Made a lot of progress but it is in the screwheads the attach the hot end. Ridiculous
Comment on Is this hot end salvageable?
brillotti@lemmy.world 14 hours agoSoften the PLA with a lighter and then peel it off
Starfarer@lemmy.today 13 hours ago
SparroHawc@piefed.world 13 hours ago
If push comes to shove, you can heat up a screwdriver tip with the lighter, and use that to melt some of the PLA in the screw head enough to unscrew it.
@brillotti @Starfarer yeah for most PLA in general I would recommend+245•C & then brief off the material look up #3DPrinting brush #tool